Switched from FM3 to FM9 - what to change first to upgrade the preset

[Polluxx]

I have been the owner of the FM9 coming from the FM3 since yesterday. I imported my main preset and the first thing that came to mind was to set the reverb quality to ultra high, which already makes an audible difference.
What else can you think of that should be taken into account immediately after such a change? My preset is relatively simple, I use comp, wah, amp, cab, chorus, reverb and delay in parallel.
I only play mono

What else can you think of?

 

[Greg Ferguson]

What else can you think of that should be taken into account immediately after such a change? My preset is relatively simple, I use comp, wah, amp, cab, chorus, reverb and delay in parallel.

Nothing. Just play with it and anything else will come with time.

BTW, I don't even bother changing the Reverb quality when I move presets between the units. In a live setting with a band the reverb quality is really hard to tell because of the rest of the band, crowd noise and room acoustics. I would only worry about it when recording a solo passage, and even then I'd probably add reverb later so it wasn't baked in.

 

[Dino334]

Nothing. Just play with it and anything else will come with time.

BTW, I don't even bother changing the Reverb quality when I move presets between the units. In a live setting with a band the reverb quality is really hard to tell because of the rest of the band, crowd noise and room acoustics. I would only worry about it when recording a solo passage, and even then I'd probably add reverb later so it wasn't baked in.

THIS ... SPOT ON!!!

 

[unix-guy]

The IR length and Cab block Preamp quality of you use it.