Splitting the signal to different effects

[Joero6]

I run my axe fx to a matrix power amp into two 4x12 cabs. I wanted to try creating a preset that splits the signal to two paths. What I would like to happen is this. Let's say I have just a stock sound that I am using as my dry sound.While playing,I would like to step on one of my expression pedals and engage let's say a whammy effect. The end result I would like, is to have the whammy sound mixed with the dry signal. Can this be done to the two different cabs? Or does the sound have to go to both cabs the same, and how do I do this? Thanks Joe

 

[NMG]

So you have two cabs run by the matrix in stereo?



Be aware that some of the blocks will make the signal mono, blending the inputted stereo signal from the grid, so its best to put the pitch block after the amp, on a seperate row, then hard panning its out put to right and hard panning the next block after the amp in the original chain to the left.