SPDIF output level?

There isn't a level control for SPDIF specifically. If you set SPDIF/AES source to Out 2 you could use a global vol/pan or filter block before the Out 2 block.

On the Axe II it's possible to echo Out 1 to 2 and set USB/Digi source = Out 2, then adjust the Out 2 global EQ gain. IIRC this wouldn't work on the III, because global EQ isn't applied to digital outputs, and the analog outs include the copied signal's global EQ instead of retaining a separate EQ.
 
Page 163 of the manual shows how to adjust the level of SPDIF output. Setup - I/O - USB/AES.

AES/SPDIF – This scales the levels of signals from the AES and SPDIF inputs. Recognize that this scaling occurs at the output of the input; that is, after the input itself but prior to any processing on the grid.
 
Don Watters said:
Page 163 of the manual shows how to adjust the level of SPDIF output. Setup - I/O - USB/AES.

AES/SPDIF – This scales the levels of signals from the AES and SPDIF inputs. Recognize that this scaling occurs at the output of the input; that is, after the input itself but prior to any processing on the grid.
Click to expand...

That's for signals received at the SPDIF/AES inputs. There's no equivalent global parameter for SPDIF output level.
 
You must log in or register to reply here.
Back
Top Bottom