Joe Bfstplk
Legend!
Yes, those are nice, and just fit in an SG SpecialView attachment 74231
this is the one to get.
Yes, those are nice, and just fit in an SG SpecialView attachment 74231
this is the one to get.
Get it where, by what name or part number?Yes, those are nice, and just fit in an SG Special
IIRC, StewMac has them. Search for push pull pot, pic should help you ID them. They have 250k and 500k short shaft and 500k long shaft for Les Pauls and other thicker-topped guitars.Get it where, by what name or part number?
Not at all...even if with the years going by they're hanging a bit lower nowadays...just thinking it really isn't a very operational solution. No sweat !I'm curious why some of you have your knickers in a twist over this post and the other one about the Tele?
The 250/500k is to keep volume pot right when changing H split to SC ?View attachment 74231
this is the one to get.
Looks like the old "contemporary strat" design from the early 80s. I have one of those in the Squier model.Never seen a locking nut like that.
Sorry, thought it was a push-PUSH switch that didn't suck after all, my bad.IIRC, StewMac has them. Search for push pull pot, pic should help you ID them. They have 250k and 500k short shaft and 500k long shaft for Les Pauls and other thicker-topped guitars.
There, apparently, is no such beastie on the push-push side, but these push-pull ones are very smooth and pull up more easily than most, and feature a full-size CTS pot to boot....a push-PUSH switch that didn't suck
Just had those put in my Suhr... Hopefully they are robust!Does anyone else hate push-pull switches on control knobs? Don't like pulling them up with a pick in my hand.
Much prefer push-push, but for some reason they're far less common, especially on production guitars.
It wasn't your post I was referring to...Not at all...even if with the years going by they're hanging a bit lower nowadays...just thinking it really isn't a very operational solution. No sweat !
it's 250 or 500 so no. You can use a four poll megaswitch and a resistor so the single coils see 250 and the HB gets 500 ,gets more complicated though.The 250/500k is to keep volume pot right when changing H split to SC ?
If its a push push go easy on it the ones available are pretty bad.Just had those put in my Suhr... Hopefully they are robust!