SOLVED: Strange Behavior MFC III - power up to random preset

BreadTooth

BreadTooth

Experienced
Maybe someone here can help a brother out.
Noticing strange behavior with AxeFx II XL v6.1 to MFC III v3.08.
When powering up, the AxeFx & MFC go through their simultaneous boot up sequence.
The AxeFx finishes booting up first, and displays the last preset I was using when the device was powered down.
The MCF finishes booting up after the AxeFx and immediately sends the AxeFx to a random preset.

The AxeFx is linked to the MFC via FASLINK.

I have never experienced this type of behavior with my AxeFx rig. It's usually consistent working order.

The last actions I've done with the AxeFx was updating to v6.1.
Nothing has been changed with the MFC101.

I have replicated this behavior multiple times. Before I downgrade the AxeFx firmware back to v5, is there a setting somewhere that I am overlooking?

Thanks in advance for any ideas or feedback!
 
This happened to me once last week on the same hardware and fw versions as you, FAS link also. I thought it was very strange but it hasn't happened since. My main presets live in the lower numbers, but that one time it jumped to a factory preset around 300. It's been power cycles about 20 times since then without it happening again.
 
UPDATE:
Installed v6.2 firmware and the power up issue has not reappeared.
Powered up the AxeFx rig multiple times and everything is back to normal.
Band practice tonight was amazing.

So happy to have my rig behaving like it always does, providing glorious tones.
 
You must log in or register to reply here.
Back
Top Bottom