bke
Inspired
HI,
Wondering what peoples opinion would be on settings for this - (other than use my ears;-)
Ive been experimenting with a clean tube poweramp (synergy 50\50) into a 112 with a celestion fx-200 speaker
I know normal advise using a poweramp into a cab would be to select resistive mode in the speaker page of the amp, then to maybe remove speaker compression drive etc..
But given its a flat amp into a flat speaker more or less) would resistive load be the best? ive tried both and i find the defailt curve's are maybe a bit much, but resistive load removes to much of the character of the speaker the ir is made from...
appreciate any opinions on optimum setup for this case,
cheers
Wondering what peoples opinion would be on settings for this - (other than use my ears;-)
Ive been experimenting with a clean tube poweramp (synergy 50\50) into a 112 with a celestion fx-200 speaker
I know normal advise using a poweramp into a cab would be to select resistive mode in the speaker page of the amp, then to maybe remove speaker compression drive etc..
But given its a flat amp into a flat speaker more or less) would resistive load be the best? ive tried both and i find the defailt curve's are maybe a bit much, but resistive load removes to much of the character of the speaker the ir is made from...
appreciate any opinions on optimum setup for this case,
cheers