Kingfloyd
Inspired
I understand how to use scenes on a single line of the grid, switching blocks on and off when changing scenes.
But I would like to use two lines of the grid (say 1 and 2) and select one or the other just changing scene. For instance, scene 1 would call line 1 (drive/amp/cab) and scene 2 would call line 2 (drive 2/amp2/Cab2). Obviously if I only switch off blocks of line 2 when using scene 1, the consequence will be that I will only have 50% of the signal going through line 1 and the remaining 50% will be unprocessed going through line 2. (At least this is the way I understand it).
Before FW 9 I used to do this using a mixer activated with an external pedal.
Is there a way to do the same just using scenes and no external switch/pedal ?
But I would like to use two lines of the grid (say 1 and 2) and select one or the other just changing scene. For instance, scene 1 would call line 1 (drive/amp/cab) and scene 2 would call line 2 (drive 2/amp2/Cab2). Obviously if I only switch off blocks of line 2 when using scene 1, the consequence will be that I will only have 50% of the signal going through line 1 and the remaining 50% will be unprocessed going through line 2. (At least this is the way I understand it).
Before FW 9 I used to do this using a mixer activated with an external pedal.
Is there a way to do the same just using scenes and no external switch/pedal ?