Scene Changes - Anomoly

bread

bread

Power User
Hi

When changing scenes that use different amp blocks I'm getting a momentary noise when the new scene is engaged.

It sounds like the wah comes on for a 10th of a second then goes back off again. Anyone else had this problem ?

It doesn't happen switching scenes that use the same amp block.


Using an XL+ with Q4.0 and MFC Mk 3
Thanks
 
With these types of questions, it's super helpful if you post a preset so people can make sure it's not a configuration issue such as bypass mode, etc.

IMO, your problem is not inherent to the Axe-FX. I don't use lots of two amp presets, but none of mine have exhibited this behavior.
 
Hellbat said:
With these types of questions, it's super helpful if you post a preset so people can make sure it's not a configuration issue such as bypass mode, etc.

IMO, your problem is not inherent to the Axe-FX. I don't use lots of two amp presets, but none of mine have exhibited this behavior.
Click to expand...


I'll put the preset up tomorrow hopefully. Thanks for your help
 
You are using 2 amp blocks or amp X/Y?

One thing to make sure of is that amps are not changing X/Y states even if bypassed in the scene... Because it will cause an audio dropout.
 
You must log in or register to reply here.
Back
Top Bottom