SAT switch

This seems very basic to me but I'm not getting it.
Normally when I send a CC value to the Axe it's always related to where that value was assigned on the IO menu.
If I want just to assign an On or OFF to the SAT switch, how do I do this since it's not in the list on the IO menu?
 
use one of the External Controllers in the CTRL list. do NOT change the number of that External Controller in that list, just note the number and set a Generic Midi command of that CC# on your pedal or whatever.

bring up the Modifier screen on the Sat switch by highlighting it and pressing Enter on the front panel, or right-clicking the Modifier [] symbol in Axe-Edit. then make the Source the same External Controller you selected.
 
Back
Top Bottom