wildolympic
Inspired
So I am running an XL + into an MRK 2 set up so far like this, MFC 3 into the axe XL+ via Econ then the XL + into the MRK2 via 5 pin midi. The MFC works fine and controls both Axes, but I have my usb running from the XL+ to my computer and it shows up in axe edit under available devices but the MRK2 does not. Do I need to run a separate usb cable from the MRK2 into my computer before it will show up? and I can switch between the two in axe edit?. Also if I want to, can I connect the MRK2 into the XL+ through input 2 L mono FX return and run it in the FX block. Hope this makes sense Thanks Tim.