Quick Question About Looping Block

[Fixated]

Sorry if this has already been asked before. I searched around but did not see any posts with this question.

Is there a way to make each loop/overdub lock in with a specific scene?

For instance, if I record my first loop with scene 1 that uses a Deluxe Reverb Scene for cleans and then overdub it with scene 2 with a Brit amp, is there a way to keep my first loop from switching from the Deluxe amp channel to the Brit amp channel?

I hope that this makes sense,
Fixated

 

[2112]

Place the looper after the amp block

 

[Fixated]

Place the looper after the amp block

Thanks a lot for the quick reply Leon! It worked perfectly.

 

[blaggers]

I either place the looper as first block after IN1 (for dialling in patches) or last block before OUT1 for jamming. It’s very flexible.

 

[Harm]

I place the looper as the last block of the chain. That way you keep everything the same when you change scenes or presets