Question about external footswitch operation

I have a single button footswitch. I know it works as I used it as a mute switch with a different piece of hardware. I was going to use this single footswitch as an off/on switch for different purposes, e.g., turning on the 'Fat' or 'Cut' on the amp, etc. I have an expression pedal plugged into Footswitch 1 (works no problem). I put this single footswitch into Footswitch 2. However, it's no communicating (activating the on/off of what I want it to). I suspect I'm doing something wrong that is a simple fix, but cannot figure it out. Any assistance appreciated. FYI, the footswitch is not TRS... single ring.
 
make sure you go into Setup > I/O > Pedal and set Pedal 2 to Momentary, rather than Continuous (which is an expression pedal).
 
Back
Top Bottom