Quantum Delay Problem?

MrFlexx

Member
I've just intstalled the Quantum firmware and on all my presets I can barelly hear the delay, even if I up it to max. How come?
 
Check the "phase reverse" parameter in delay block. If it's set to "left" or "right" delays can become quieter or silent if channels get summed afterward.

If that wasn't it:

Are these factory presets or ones you've created/adjusted? Can you post one or more presets where this happens?

When you say "up it to max", which parameter are you referring to?

Do you have any modifiers assigned to delay parameters like level, input gain, mix?
 
MrFlexx,

If you upload a preset where the problems occurs it will be a lot easier to try to help you. Or if you create a new preset from
scratch does it react the same way ?

also do you have a mark I or II or XL ?

:)
 
Thanks all for the help. I found the problem. It was the phase delay that was the problem. Now it all works fine :)
 
Back
Top Bottom