Quantum 1.03 Modifier Value [NOT A BUG]

I couldn't remember, but I was positive the value changed as the dial was moved. I know you can't enter a number by typing it in.
 
Previously Axe-Edit would show the modifier-controlled value. This changed at some point, possibly several years ago when standard/Ultra modes were dropped.

The value shown now is what's stored in the preset and used if PC RST enabled for modifier, same as front panel. This is probably intentional.

It's possible to type a parameter value while a modifier is assigned. Was that a typo in your last post? Keep in mind this value would only affect the initial value on the preset, if PC RST is enabled and the source hasn't yet taken over the parameter.
 
Back
Top Bottom