Ytolyccuz
Inspired
Hi Everyone,
It's my first try at reamping and I was surprised there was no setup at all. However, I'm not sure if I'm missing something. After recording, it sounds slightly different. It's as if the channels sound "separate". Is this an example of phasing? Am I missing something? This is what I did:
Axe Fx 2 mk 2
Drive: T808OD
Amp: Atomica High
Cabinet: Ownhammer Justin York MES 4x12
Delay: Studio Tape
Reverb: Studio
It's my first try at reamping and I was surprised there was no setup at all. However, I'm not sure if I'm missing something. After recording, it sounds slightly different. It's as if the channels sound "separate". Is this an example of phasing? Am I missing something? This is what I did:
- Set the input on Axe Fx 2 back to Analog In 1
- In Ableton, used channel 3 and 4 to record the raw guitar.
- Set the input on Axe Fx 2 to USB
- used channel 1 and 2 to record the processed signal
- Set the input on Axe Fx 2 back to Analog In 1
Axe Fx 2 mk 2
Drive: T808OD
Amp: Atomica High
Cabinet: Ownhammer Justin York MES 4x12
Delay: Studio Tape
Reverb: Studio