Problem Using 2 Guitars - Need Assistance

[Warrior]

I have my preset setup like below. Guitar 1 is running to front "INST", Guitar 2 is running to "Instrument" in back.
Can't figure out why I get no input/output signal for 2nd guitar.

In 1 - blocks - out 1
In 2 - blocks - out 2

Could it be my I/O settings?

Currently, USB Output 7,8 Source is set for INPUT 2

 

[Jon Fenton]

I have my preset setup like below. Guitar 1 is running to front "INST", Guitar 2 is running to "Instrument" in back.
Can't figure out why I get no input/output signal for 2nd guitar.

In 1 - blocks - out 1
In 2 - blocks - out 2

Could it be my I/O settings?

Currently, USB Output 7,8 Source is set for INPUT 2

From memory, I think that the instrument output on the front panel will always simply override the instrument input on the back panel. Thus your unit is operating correctly and just outputting the first guitar which is overriding the second guitar.

In your case, I think you need to use the front panel input for guitar one and a different input on the back panel (input 2 or three etc) for guitar two. Then set up your grid to reflect this.

 

[Bakerman]

 

[Warrior]

Ah.... when I plugged into the back, I was leaning over the unit and I didn't see the "INPUT 1" above the Instrument input.
Makes sense now.

Thanks!

 

[yyz67]

[SOLVED]