FW 11.2, I believe.
Relatively new Mark 2 Axefx 2 first won't startup at all, and just shows a blank screen (that is lit) with all LEDs on. Re-started by holding down the 'Recall' front panel button. Don't work for a while. Kept restarting it multiple times, and finally got the proper start-up display and LED movement. It would display the current preset, but the large value knob and quick control knobs don't do anything now. After about ten seconds, the screen then goes blank (lit, but with no text).
When I try this again with Axe Edit 3, a connection becomes established, it shows the current preset, but when I try to change to another preset, Axe Edit displays "Communication Failure: Axe-Edit was unable to complete the communication request due to time-out".
What is going on?
Relatively new Mark 2 Axefx 2 first won't startup at all, and just shows a blank screen (that is lit) with all LEDs on. Re-started by holding down the 'Recall' front panel button. Don't work for a while. Kept restarting it multiple times, and finally got the proper start-up display and LED movement. It would display the current preset, but the large value knob and quick control knobs don't do anything now. After about ten seconds, the screen then goes blank (lit, but with no text).
When I try this again with Axe Edit 3, a connection becomes established, it shows the current preset, but when I try to change to another preset, Axe Edit displays "Communication Failure: Axe-Edit was unable to complete the communication request due to time-out".
What is going on?