GtarGreg
Inspired
Hi ya'all!
I'm hoping you can help. I have a Seymour Duncan PowerStage and a standard cab. I love the JCM800 amp as my go-to classic rocker. I also want to run direct FOH. Can someone post an example patch for this config?
Notes: I've split the signal before the cab and noted to turn off spkr drv and comp in the amp block. My effects are in the front of the amp, including reverb. The trick is, I used to adjust the speaker block to level my patches (1-clean 2-crunch 3-higain 4-(over the top)). I used Scene controller 1 for the input drive and Scene controller 2 for speaker volume/output.
How might I acheive the same type setup with the split? My attempt is attached #FAIL. LOL
Thanks.
Greg
Hey Fractal, I'm eagerly awaiting my FM3!
I'm hoping you can help. I have a Seymour Duncan PowerStage and a standard cab. I love the JCM800 amp as my go-to classic rocker. I also want to run direct FOH. Can someone post an example patch for this config?
Notes: I've split the signal before the cab and noted to turn off spkr drv and comp in the amp block. My effects are in the front of the amp, including reverb. The trick is, I used to adjust the speaker block to level my patches (1-clean 2-crunch 3-higain 4-(over the top)). I used Scene controller 1 for the input drive and Scene controller 2 for speaker volume/output.
How might I acheive the same type setup with the split? My attempt is attached #FAIL. LOL
Thanks.
Greg
Hey Fractal, I'm eagerly awaiting my FM3!
Attachments
Last edited: