Possibly a bug, assigning High/Low cut and other cab block parameters in the Perform tab

nikk©

Inspired
I 've tried to assign the Low / High Cut cab block settings in the Perform tab

For the CAB 1, everything is fine and the buttons are correctly labelled: CAB1 Low Cut & CAB1 High Cut

and when I want to assign CAB2 or CAB 3 Low Cut / High Cut, they are well assigned to the right parameters, but remain labeled CAB 1

same thing for the Cab more / IR Length parameters!

THANKS
 
I confirm I get the same results on my unit. I even made sure Cab2 wasn't muted, just in case that had some effect, but Cab1 is displayed in both cases.
 
Back
Top Bottom