Possible to get L and R Outputs at different levels?

[barhrecords]

I want to run Out 1 L -> FOH and Out 1 R -> vocal processor.

I need Out 1 R to be -12db relative to Out 1 L.

I also want L and R to be discrete mono.

Is this possible?

 

[painkiller]

How about the balance control in the output mixer?
For mono I would set the Output Mode in the audio settings to SUM L+R.

 

[barhrecords]

How about the balance control in the output mixer?
For mono I would set the Output Mode in the audio settings to SUM L+R.

I thought the balance / pan controls used an equal power algo? My assumption was the output level would remain constant when signals were panned.

 

[painkiller]

Sorry, I missed that the balance of the output mixer only works this way if you set the output to stereo.
If you set the output to SUM L+R the behavior is like you described.

 

[Bakerman]

Do you have separate rows for the signals meant for L & R outputs?

Assuming yes: balance them L/R at output mixer. Adjust level of each row as needed.

A block near/at the end of either chain could also be used for this.

Set output 1 mode to "stereo".