Pitch and 4.01 update

D

dosmun

New Member
Just a heads up. I updated my VP4 a couple days ago and played a show last night, When I would go to a harmony preset the Harmony was gone. I fired up my board this morning and discovered that the HIGH CUT on the PITCH block was set to 200Hz which pretty much eliminates the harmony. Simple fix but, lesson going forward is to try all presets after an update to confirm everything is working the same.
 
Last edited:
dosmun said:
Just a heads up. I updated my VP4 a couple days ago and played a show last night, When I would go to a harmony preset the Harmony was not gone. I fired up my board this morning and discovered that the HIGH CUT on the PITCh block was set to 200Hz which pretty much eliminates the harmony. Simple fix but, lesson going forward is to try all presets after an update to confirm everything is working the same.
Click to expand...
Did you mean ‘was not there?

I always go through my gigging presets right after a FW update to see if anything needs tweaking. After that I do a backup. Every time.
 
Domct203 said:
Yea I got that. I’m guessing you meant the pitch block was not gone?

It’s obvious that the harmony was gone with that high cut.
Click to expand...
Auto correct or fat finger🤣. Should be "harmony was gone"
I see the update extended the High cut down to 200Hz. Must have changed the default setting to that. Default should really be on the high end. I got lucky that I noticed this right away but, really isn't the first place I would think to look if I was setting something up from scratch.
 
You must log in or register to reply here.
Back
Top Bottom