Phaser start point

[siska25]

Hi.

I have a sound with a phaser in it. But every time i engage the phaser block the phaser starts at a diferent point. I'd like it to start always at the same point. I could send a midi command from a midi controller but i don't see a "run" parameter or similar, but I guess it is possible somehow.

Any idea?

Thanks.

 

[unix-guy]

Check the highlighted setting below. I think that will solve your problem.

 

[siska25]

Hi unix-guy.

I suspect that page is of a manual for an axe fx 3... Anyway "LFO bypass reset" is what I was looking for.

Thanks a lot.

 

[unix-guy]

Hi unix-guy.

I suspect that page is of a manual for an axe fx 3... Anyway "LFO bypass reset" is what I was looking for.

Thanks a lot.

No... It's the Fractal Audio Blocks Guide. It applies to all current modeling devices.

https://www.fractalaudio.com/downloads/manuals/fas-guides/Fractal-Audio-Blocks-Guide.pdf

Edit:

Oh... Just realized that you're posting about an Axe Fx II. Sorry for any confusion!