flying_walrus
Experienced
on the Axe FX and Aax8 currently there's one "FX Loop" block for something that very few of us are using as an fx loop.
on the AxeFX this is OK because you can use the feedback send/return blocks to route the output of the fx loop block where you need it, but these blocks are missing on the Ax8.
i propose to replace the fx loop block with a pair of blocks: Output 2 and Input 2.
this would make the second inputs on the units a lot more useful for those of us that want to, for example,
on the AxeFX this is OK because you can use the feedback send/return blocks to route the output of the fx loop block where you need it, but these blocks are missing on the Ax8.
i propose to replace the fx loop block with a pair of blocks: Output 2 and Input 2.
this would make the second inputs on the units a lot more useful for those of us that want to, for example,
- route the piezo output from our guitar through a fishman or TC pedal, the mag PUs into the Ax8, then run the fishman into input 2 so they can share modulation and time-based effects... while using output 2 for back line cabinets and output 1 for FOH
- use an outboard synth pedal into input 2, while using output 2 for backline and output 1 for FOH
- etc, etc.
