Output 1 on Axe-Fx III

[jfuchs18]

So I have enough FRFR cabs to utilize all 4 outputs for Output 1 (two 1/4 in. & two XLR). Can it be problematic using all four at once? Should I use two of them and daisy chain the cabs to each other? Just wondering if anyone is in a similar situation and what would work best.

Thanks in advance.

 

[FractalAudio]

Either way is fine.

 

[hippietim]

@jfuchs18 depending on your scenario, you could also have one pair coming out of Out 2 (or Out 3/Out 4) so you can have separate volume controls from the Axe front panel each pair. All you need to do is configure the Out 2/3/4 to copy from Out 1 - see page 162 in the manual: https://www.fractalaudio.com/downloads/manuals/axe-fx-3/Axe-Fx-III-Owners-Manual.pdf

 

[Joe Bfstplk]

I wonder how the AxeFX3 would sound in quadrophonic....

 

[electronpirate]

Haas delay's on all of them...HUGE.

(Although I would daisy chain 2x2...one/two output to 2 cabs.)

Either way, a fun experiment.

 

[chucma]

I wonder how the AxeFX3 would sound in quadrophonic....

Almost like this, I remember Yek did an experiment with 4 FRFRs, I think he did a "surround sound" preset by placing all 4 FRFRs around him. It was pretty fun but hard to replicate as you need 4 FRFRs!

 

[sb-SG]

I run it like this most of the time - loads of fun if you like spatial stuff - eg echos bouncing round 4 channels in 4 corners of a room.
Possibilities are endless - but we know this.....

 

[yyz67]

I wonder how the AxeFX3 would sound in quadrophonic

I remember Yek did an experiment with 4 FRFRs, I think he did a "surround sound" preset by placing all 4 FRFRs around him

Why stop at 4 channels which is only x/y planar 2D? With all the outputs someone needs to try octophonic x/y/z spatial 3D!