addedc
Experienced
I had some unexpected switching issues at rehearsal yesterday using OMG9. My presets are in the user bank, up around number 380. In Preset Mode if I tried to go bank right or left, the unit would skip the next set of presets and instead revert to around preset number 10. This made the mode unusable for more than one bank of presets. Also in either Scenes or Effects mode, a switch with a preset number was showing up out of place with the other five that were correct (happened fast so not exactly sure what it was). And on one occasion hitting a select switch on the FM3 resulted in a completely blank switches on both units. Rebooting fixed this.
Note that I did upgrade FM3 firmware to 1.4 but rolled back when I noticed the settings issues. (When I rolled back, the 3 or 4 presets that I had edited in version 4 using the editor disappeared). I installed OMG9 using a Windows 10 PC, following all supplied directions and disabling the FC Master Layout Switch Combo as recommended. I did edit Layout 3, the Effects switches, to replace effects on a few switches.
Has anyone experienced similar, have a solution or should I just reinstall?
Note that I did upgrade FM3 firmware to 1.4 but rolled back when I noticed the settings issues. (When I rolled back, the 3 or 4 presets that I had edited in version 4 using the editor disappeared). I installed OMG9 using a Windows 10 PC, following all supplied directions and disabling the FC Master Layout Switch Combo as recommended. I did edit Layout 3, the Effects switches, to replace effects on a few switches.
Has anyone experienced similar, have a solution or should I just reinstall?