not sure if bug but I almost blew my ears off

[Cobrango]

using firmware 18b7 I was just trying to come up with a new amp tone and in the preamp section of the cab block using high res and high quality preamp mode I set the saturation to 5. I experimentet with the saturation and drive, realizing that the volume dropped pretty hard when maxing them, no problem but when I had the saturation at 5 and the drive at 10 I used axe-edit and double clicked the drive parameter to turn it from 10 back to original right? Well it went straight from 10 to 0 causing a big pop which was so loud (I'm using headset but at low volume, I'm always concerned about volume) that I was afraid to hear some ringing afterwards, but luckily that did not happen. The double clicking in axe-edit can sure be dangerous if you don't know what you're doing oh my. the pain, in my ears :O

edit, I think I've had pops before doing stuff but this was.. scary over the top kind of pop.