Not seeing new amp models in 7.0

[vintageguitarz]

I might be missing something but did the Firmware update twice and rebooted my macbook twice. I do not see these amp models in the new version. Any help would be greatly appreciated.

Added “Herbie” amp models based on a Diezel Herbert.
Added “Dizzy” amp models based on a Diezel VH4.
Added Friedman Dirty Shirley amp model.
Added “Division13 CJ” amp model based on Divided by 13 CJ11.
Added “Solo99 Rhythm” amp model based on Soldano X99 Crunch channel. Added “Sure Weasel” amp model based on a Suhr Badger.
Added “Spawn Fastrod” amp model based on Splawn Quickrod.
Added “Prince Tone 2” based on a Fender AA964 Princeton. This particular amp is an early CBS “Silverface” but still using pre-CBS design and components.
Replaced the “Brit 800 Mod” model with “Brit Super” based on a Marshall AFD100.

The zen master drive did not show up either although some of the other additions did. Go Figure.

 

[notalemming]

Where are you looking, on the Axe itself or Axe Edit? If it's Axe Edit, that needs to be updated too.

 

[vintageguitarz]

Thanks much. I did not realize there was also an update to Axe Edit. Oops!!!!!

 

[javajunkie]

Thanks much. I did not realize there was also an update to Axe Edit. Oops!!!!!

everytime there is a firmware update that adds models or parameters, you need to have an updated version of axeedit, to the new parameters in axeedit.