[Not a Bug] Stand-In Switch changes Tempo?

[Tigerfish]

I have a stand-in switch that I use to activate the Looper - Layout 5. Tap switches to Layout 5 and Hold selects Layout 7, my preferred performance layout. BUT whenever I tap the switch the tempo changes - first to 250 then randomly after that. I can't find anywhere that I have programmed this behavior so it must be a bug? If anyone has any ideas about where to look for a command that would be making this happen, I would appreciate them.

 

[BryantP]

If you upload your "System + Global Blocks + FC" backup from FractalBot, I will take a look. If this is specific to a preset or presets, that backup would also be helpful/crucial.

 

[Tigerfish]

All my user presets are in Block D so that's in this backup as well.

 

[BryantP]

Thanks! I'll try to take a look before I leave today and let you know what I find.

 

[BryantP]

This is a bug, @Tigerfish. I'll try to get a fix in for the next release of the Axe-Fx III firmware. Will keep you in the loop and I apologize for the inconvenience.

 

[Chad Beattie]

Thanks. I was wondering how my temp was changing also

 

[BryantP]

Thanks. I was wondering how my temp was changing also

On closer inspection, this is a configuration issue. If you go to HOME->SETUP->MIDI/Remote->Other page, Tempo Tap is set to FC 1 SW 3. Change that to NONE and you should be good to go.

 

[Tigerfish]

Problem solved - thanks for finding that!