Airgolas
Member
This morning I noticed I wasn't getting output on a few presets. Input meters were firing but no output. I have about 10 presets where I use the same Amp block. Some have output, some do not. In the Amp blocks with no output, the output level is pegged at 20db (I did not set it there). If I bypass the amp block in these presets, I get clean sound out. I copied an amp block from a presets where the amp block was working, and after paste, the amp block's level pegged to 20db (from -14db before paste) and I get no output. I am on FW 1.04 beta. Also, if I bypass the amp block in edit using the bypass button in the lower right-hand corner of the amp block window, I cannot re-engage the amp block using the same button. I have to use the bypass/engage command by right clicking on the amp block itself. I have also power cycled the unit once already with the same result.