guitvai1
Inspired
I'm on FW 18.07 and it was working after upgrade. Decided to do a systems parameter reset and now I'm not getting any output. I normally go output 1 into Matrix GT1000Fx into 2 matrix passive monitors (Q12s).
- using the front input.
- outputting to Output 1.
- have checked Global Parameters and Pwr amp modeling is on and cab modelling is active
- disconnected MFC101
- on IO page - Input 1 Left Select Front
Output 1 mode is Stereo.
Not sure what I'm overlooking, anyone have any ideas? Also I can see input and output lights flashing when strumming.
Thanks,
- using the front input.
- outputting to Output 1.
- have checked Global Parameters and Pwr amp modeling is on and cab modelling is active
- disconnected MFC101
- on IO page - Input 1 Left Select Front
Output 1 mode is Stereo.
Not sure what I'm overlooking, anyone have any ideas? Also I can see input and output lights flashing when strumming.
Thanks,