No midi CCs received until selection of other preset

6

666was999

Fractal Fanatic
Hi there,
whenever I power my II I first move all connected pedals a bit to get the pedals and the modifiers in sync.
That's how I am used to it.
With 10.00 it seems there is no reaction on pedal moves until I leave the preset from the powering. Midi LED is dead too.
Once I left that first preset the midi CCs work right again.
So it's nothing severe, just wondering. Is there anybody else here noticing the same behavior or is on mine only?
Thanks!

Setup:
II FW 10.00,
MFC FW 2.15,
connected via CAT5,
Roland EV-5 pedals
 
I think an issue that I've noticed with v10 is another symptom of the problem the OP reported... When I power on the Axe-Fx, the MFC has no effect., the Axe-Fx doesn't respond to it. If I unplug the ethernet cable, then plug it back in, the preset that the MFC was set to will be reselected, and the Axe-Fx will respond to the MFC.
 
I saw this as well and heard from Matt about it. It's an issue that will be resolved by an upcoming MFC update. Soon. The workaround in the meantime is to change presets via the MFC or enter and exit Edit mode on the MFC.
 
You must log in or register to reply here.
Back
Top Bottom