Or even better: adding a single IA set to 'generic X/Y' would suffice. Press it once to get into Select mode, then press an effect IA to switch between its X and Y state.
No more need for a separate X/Y-switch for each X/Y-enabled effect.
nothing to do with Axe-Edit, you have to use a SysEx tool....would be cool it they eventually add this feature to Axe-Edit
Others may want to chime in if I am talking B.S. as I have not personally done a dump on the MFC-101 (yes I know what I just said :mrgreen) But I have done this on other devices, Eventides etc and they all work in the same way.
Set the SysExLibrarian to "Record", then do the dump from the menu on the MFC-101 and you should see it in the SysExLibrarian interface...if not....check your MIDI connections and preferences in SysExLibrarian.
would be cool it they eventually add this feature to Axe-Edit
Still have the MIDI cable in the MFC's MIDI IN instead of OUT?
MIDI OUT when I load INto the MFC??
I get this same message! Used Sysex Librarian. And my MFC101 skips presets by 5's 5 -10 -15- 20 wtf?Hmmm....I don't got it working
the MFC is updated, but the thing with the converter didn't worked.
At last I got the message: "Axe FX Name Timeout" ....
grmbl...
Hi, I did the re-boot and hold 11 but sorry I dont know what you mean by when you say---but *before* you dropped your converted settings file back in----- I just got the MFC so I have no personal settings on it.Did you guys do the system reset (hold down 11 when booting up) after the update, but *before* you dropped your converted settings file back in?
Hi, I did the re-boot and hold 11 but sorry I dont know what you mean by when you say---but *before* you dropped your converted settings file back in----- I just got the MFC so I have no personal settings on it.
Thanks you for reply
Sorry. I've looked in the manual (the latest downloadable one too), Here's what I didI was actually referencing the poster above you.
What are your bank settings at (your problem of skipping 5-10-...etc)? Can you be more specific as to what is happening?
Sorry. I've looked in the manual (the latest downloadable one too), Here's what I did
downloaded the update
installed Sysex Librarian
hooked up the midi out of my midi sport to midi in of mfc
turned on and held 1
added the update into sysex librarian and the update started when i clicked play.
after 100% complete i turned off the mfc
then turned it on holding 11 and it says AXE-FX name timeout. If i go to the up down foot switches it goes from 00 to 005 to 010 to 020 it skips. Sorry I don't know more yet :-(