Need some help w/ cc assign

[frankiev]

Im setting up the looper and Im going to use 4 external footswitch plugged into the MFC to control rec play dub and bypass . This was easy thanks to clear directions in the manual . Id also like to use the pedal sw in the Axe 2 to control undo cc# 120 i believe . I found how to set the pedal to toggle in the manual but im confused on hoe=w to set the cc# for the pedal . Can someone give me some advice
TX

 

[chris]

are you familiar with the I/O menu and Control Page? it has all of the CC#s listed for everything that is controllable.

looper undo defaults to CC# 121. to set anyone of these controls to utilize the Pedal input on the axe itself, change the CC# from 121, in this example, to PEDAL in the I/O Control page.

then set up the parameters on the Pedal page in the I/O menu.

 

[frankiev]

Ok ,change the cc for undo from 121 to pedal . Thanks