GotMetalBoy
Power User
I contacted Tremol-No Support but haven't heard back. Below is what I emailed them:
I recently bought a Dean Razorback X-Ray guitar that has a Floyd Rose and tried to install a Pin-type Tremol-No but can't figure out how to install it so the shaft is perpendicular to the trem block. I tune the guitar to Drop D (DADGBE), so the top spring is looser than the other 2 springs and so the Floyd Rose is parallel to the guitar body. If I adjust the claw, so the shaft is perpendicular to the trem block, then the Floyd Rose is uneven with the guitar's body and is awkward to play.
Do you have any suggestions how to make this work?
Here's the link to the Tremol-No Support page that has the Installation Instructions, Parts Diagrams & Technical Information:
Tremol-No™
I recently bought a Dean Razorback X-Ray guitar that has a Floyd Rose and tried to install a Pin-type Tremol-No but can't figure out how to install it so the shaft is perpendicular to the trem block. I tune the guitar to Drop D (DADGBE), so the top spring is looser than the other 2 springs and so the Floyd Rose is parallel to the guitar body. If I adjust the claw, so the shaft is perpendicular to the trem block, then the Floyd Rose is uneven with the guitar's body and is awkward to play.
Do you have any suggestions how to make this work?
Here's the link to the Tremol-No Support page that has the Installation Instructions, Parts Diagrams & Technical Information:
Tremol-No™