Multiplexer quesion

flying_walrus

Experienced
my axe III is making it's way to me, so I'm reading through the manual trying to wrap my head around the new blocks.

If I run 2 amp blocks into a multiplexer block, set the bypass to "thru" on the multiplexer, and then bypass it... does it just mix both amps at full volume (thus doubling my signal at that point in the path) ?
 
Note that engaging/bypassing is one way of using the MUX and a limited one.

More possibilities when using channels in the MUX.
 
The MUX block can be bypassed and mixes all inputs, along with an undesirable volume boost from mixing multiple input rows. I've reported this as a bug for the last couple of firmwares. I think it is intended to work like the mixer block, but simpler just for switching inputs. The mixer cannot be bypassed (although strangely, you can assign bypass CC numbers on the MIDI setup page).
 
Last edited:
Okay, then disregard my answer in post 2. I can't recall it doing this when I tested it. I'll try again.
 
Back
Top Bottom