Multiple signal paths, two guitars at the same time with different effects ?

S

SimonDreyer

Inspired
Hi Folks
Just lookig at the block layout you should be able to run two seperate effects paths. Path 1 using Input 1, through grid and effects 1 to Output 1, no problem. Then using Input 2 and Output 2 with the RETURN, SEND & EFFECTS LOOP on a seperate grid line as follows:

[RTN]-[FXL]-[...Effects blocks here...]-[SND]

The signal should go into the RETURN of the FXL block, through the effects in the line then routed back to the SEND of the FXL Block via the SEND and RETURN Blocks.
Neat or what? you could run your vocals or even the entire FOH mix?

Cheers Simon
Axe <---> (o)===:::
 
That would work. You can also use balance/panning controls inside certain blocks to split the Input 1 left and right into two signals for separate processing and output.
 
yes, you can already do this with an Axe 1... it can be usefull if you play with an FRFR setup and the Bass guy amps frys... or if the voice PA Fails
 
You must log in or register to reply here.
Back
Top Bottom