Multi tap delay

the release notes don't mention it. i'd like to know officially, but i know they said on the forum that it was fixed in the next firmware (which would be 14).
 
It is fixed. However certain presets may require a manual reset by deselecting and reselecting the desired type.
 
Isn't there some settings that relinks all the blocks in utilities or global or somewhere.

Is there any possibility that if we go to a preset using multidelay, the speakers will burn

That post had me worried
 
Nagi Mysore said:
Isn't there some settings that relinks all the blocks in utilities or global or somewhere.

Is there any possibility that if we go to a preset using multidelay, the speakers will burn

That post had me worried
Click to expand...

Just keep your volume turned down or use headphones again with the volume down and its a non-issue. I think anytime you update you should check all your presets at low volume, just my opinion.
 
You must log in or register to reply here.
Back
Top Bottom