Axelman8
Experienced
Hey there
Here is the start of the mockup build.
Going to build it fully, and wire/ solder the screens and footswitches while attached to this board. The polyglass will be used to make the final enclosure (wood finish). The screens will be protected bij this polyglass, so i hope to make the PCB beer proof
@prongs_386
Question for you. Does your programme have a button "HOLD" function as in a long press?
Cheers
Here is the start of the mockup build.
Going to build it fully, and wire/ solder the screens and footswitches while attached to this board. The polyglass will be used to make the final enclosure (wood finish). The screens will be protected bij this polyglass, so i hope to make the PCB beer proof
@prongs_386
Question for you. Does your programme have a button "HOLD" function as in a long press?
Cheers