After some testing, I found many of them. Here they are listed by 'Tabs'....
@BryantP
Axe-Fx III Firmware 14.04 - Axe-Edit III 1.07.01
FM3 Firmware 1.06 - FM3-Edit 1.01.10
'Tempo/Pitch'
'LFO 1 + 2'
'ADSR 1'
'ADSR 2'
'Sequencer'
'Envelope/Manual'
'Scene Ctrl 1+2'
'Scene Ctrl 3+4'
'CS Per Scene'
@BryantP
Axe-Fx III Firmware 14.04 - Axe-Edit III 1.07.01
FM3 Firmware 1.06 - FM3-Edit 1.01.10
'Tempo/Pitch'
- Input Source value not included
- All three 'Metronome' parameter values not included
'LFO 1 + 2'
- LFO 1 - Astable Beta value not included
- LFO 1 - Quantize value not included
- LFO 1 - High Cut (doesn't exist in the FM3 at this time)
- LFO 2 - Run/Stop value not included
- LFO 2 - Astable Beta value not included
- LFO 2 - Quantize value not included
- LFO 2 - High Cut (doesn't exist in the FM3 at this time)
'ADSR 1'
- Input Source value not included
'ADSR 2'
- Input Source value not included
'Sequencer'
- Damping Time value not included
'Envelope/Manual'
- Low Cut - Always defaults to '20.000 Hz' (the default)
- High Cut - Always defaults to '200.00 Hz' (default is 20000 Hz)
- All 5 Manual controller values are not included
'Scene Ctrl 1+2'
- All 16 Scene values not included
'Scene Ctrl 3+4'
- All 16 Scene values not included
'CS Per Scene'
- No Issues here
Last edited: