More DynaCabs on the horizon?

MisterE

Fractal Fanatic
Loving the latest with more mike options.
I would love to see some more DynaCabs.
Perhaps a BlackBack or the G65?
Are there any plans for more or are some in the making?
 
I hope to get more dynacabs packs. I bought a few of the available ones and cannot believe how good they are and how easy it can be to dial in sounds.
 
Dynacab pack ... I like to blend a condenser and dynamic mic, which takes a lot of cpu with the internal DC.
I just checked on my FM3, cause it's the little guy, using a Legacy factory IR, and a factory Dyna-Cab to see how the CPU was affected…
Screenshot 2024-11-08 at 10.20.21 AM.png
Screenshot 2024-11-08 at 10.21.04 AM.png
Changing Cab options might increase it a little, but at the defaults the factory DCs aren't going to cause a big hit by themselves. Totally maxing out some of the Room/Air settings will make it climb but that's extreme.
Screenshot 2024-11-08 at 10.28.39 AM.png
 
If I were to get a wish, it would be for the 2x10 Super cab to be the next cab pack added. I use the built-in one quite a bit, and it's also handy for the places where you'd use the Bassguy 4x10 (not the RI one) if you use the Bassguy impedance curve....
 
I just checked on my FM3, cause it's the little guy, using a Legacy factory IR, and a factory Dyna-Cab to see how the CPU was affected…
View attachment 147761
View attachment 147762
Changing Cab options might increase it a little, but at the defaults the factory DCs aren't going to cause a big hit by themselves. Totally maxing out some of the Room/Air settings will make it climb but that's extreme.
View attachment 147763
I am using the some room/air and Cab preamp, but I remember this being a much bigger gap. I may have compared on an older beta firmware on my af3. I will have to check again on both the af3 and fm9 now that I’m on release fw on both. Hmmm
 
Back
Top Bottom