Legacy Presets Moke's Axe-Fx II 'Clean to Mean' Pack #2 (Best of Banks B&C) - Updated for Q10.01

Third party presets or preset packs for sale for legacy Fractal Audio products.
Moke

Moke

Axe-Master
Vendor
I figured that I would start a separate thread for each of these 'Packs' to make it easier to have a better discussion?

Axe-Fx II 'Clean to Mean' Pack #2 is now updated for Q9.03.

Set the new 'Speaker Comp' parameter so that there is about -3 dB of compression. Adjusted for any loss of high-end. Then re-dialed the levels of the presets and the four scenes for all 110 presets.

A little over 16 hours for this one.....

Free for anyone that has already purchased the pack. Just use the same 'Archive/Update' link. The new zipped file has 'Q9.03' in the name.

Currently, the only "Factory" presets available that are fully compatible with Q9.03....;)
 
levipeto said:
How can we get the updated version?
Click to expand...
You should have gotten a PDF file with the 'Future Update' link inside, along with zipped file. That link will take you to the 'Archive/Update' page. If you missed placed the PDF file, just contact me through my site, and I will send you another one.
 
Just finished updating the Axe-Fx II 'Clean to Mean' Pack #2 for firmware Q9.04. Set the 'Preamp CF Hardness' to the new default of '7.50' in all Amp blocks. Then checked and re-dialed the levels of the scenes, and a few other small changes.

As usual, free for those that have already purchased it.
 
My Axe-Fx II 'Clean to Mean' Packs #1 and #2 have been updated to Q10.01.

New for Q10.01... Now available in three different versions. For 'High Output Pickups' (the original version), 'Medium Output Pickups', and 'Low Output Pickups'.

Try a couple of presets from each version to see which one works best for your guitar(s). You can also mix and match them to work with multiple guitars. You could, for example, use all three versions of a particular preset and re-name them for your EMG/Schecter, your PAF/Les Paul, and your Single-Coil/Tele.

Of coarse you may still need to make some adjustments for your exact guitar/pickups (such as turning off the 'Bright' switch for Single-Coil guitars, adjusting 'Bass', Mid', 'Treble', 'Presence' etc...).

Free update for anyone that has already purchased.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom