Loopback777
Inspired
I'm using the Mixer Block tied to a pedal to change between a crunch and clean tone, but I've noticed on the clean tone (when I'm on my own without the band and things are quiet - or on recording playback) that I can just barely make out the crunch. I've recalibrated the pedal. How can I clean this up completely?
Gain (on the mixer block)
Source Extn 1
Min 0
Max 1
Start 0
Mid 50%
End 100%
Slope 50%
Nevermind - I hadn't calibrated since my last update (both Axe and MFC). All cleared up!
Scale 1
Offset 0%
Damp 10ms
Autoeng off
Off val 5%
PC Rst off
Both Gain settings are identical, except the Start and End percentages are reversed.
Gain (on the mixer block)
Source Extn 1
Min 0
Max 1
Start 0
Mid 50%
End 100%
Slope 50%
Nevermind - I hadn't calibrated since my last update (both Axe and MFC). All cleared up!
Scale 1
Offset 0%
Damp 10ms
Autoeng off
Off val 5%
PC Rst off
Both Gain settings are identical, except the Start and End percentages are reversed.
Last edited: