MIDI switching CC on/off question

fromthebark

Experienced
OK. I don't really know how to phrase this question. I use my Axe FX II with an FCB1010 in stomp mode w/ the Eureka eprom. I am trying to run two amps in parallel, and have one switch turn Amp 1 off and Amp 2 on. But the MIDI commands a footswitch press sends is either going to be ON or OFF right? This is kind of something I need to do with Scenes, or X/Y I'd imagine.
Unless theres some way to make this work that my feeble brain can't compute at this hour.
 

Attachments

  • Screen Shot 2020-03-06 at 9.01.44 AM.png
    Screen Shot 2020-03-06 at 9.01.44 AM.png
    681.8 KB · Views: 6
If you configure a switch as an External Control, it can act as bypass modifier source for both amp blocks. Swap start & end values of one modifier to make them bypass oppositely.
 
You can't easily do it with CC only with the Eureka chip. I've been very disappointed with that chip's limitations. It can be done easily with the stock FCB & with the Uno chip. Another way to do it is with scenes and that can be handled by the Eureka.
 
Back
Top Bottom