Thedeermunk
New Member
Hello everyone,
I'm having an issue syncing my Nektar Pacer MIDI foot controller to certain parameters within in my FX8 MKII.
The message to trigger certain parameters within my FX8 do not cover the full range of expression. For instance, I programed a foot switch to toggle the hold on my reverb, but it covers so little range, I actually have to adjust the offset in order to pass the 50% where it is triggered. I attached screenshots to show exactly what I'm looking at within the FX8 editor.
Am I just not sending the right MIDI signal to make it go all of the way? I'd like for it to cover the full range in order program swells etc... I included screenshots of my Nektar editor as well to show exactly what programing options I am using as well as more options. Thanks in advance!
-Mike
I'm having an issue syncing my Nektar Pacer MIDI foot controller to certain parameters within in my FX8 MKII.
The message to trigger certain parameters within my FX8 do not cover the full range of expression. For instance, I programed a foot switch to toggle the hold on my reverb, but it covers so little range, I actually have to adjust the offset in order to pass the 50% where it is triggered. I attached screenshots to show exactly what I'm looking at within the FX8 editor.
Am I just not sending the right MIDI signal to make it go all of the way? I'd like for it to cover the full range in order program swells etc... I included screenshots of my Nektar editor as well to show exactly what programing options I am using as well as more options. Thanks in advance!
-Mike
Attachments
-
Screen Shot 2020-06-10 at 8.53.12 PM.png488.4 KB · Views: 0
-
Screen Shot 2020-06-10 at 8.53.19 PM.png625.3 KB · Views: 0
-
Screen Shot 2020-06-10 at 9.06.56 PM.png157.8 KB · Views: 0
-
Screen Shot 2020-06-10 at 9.07.11 PM.png478.5 KB · Views: 0
-
Screen Shot 2020-06-10 at 9.07.24 PM.png201.8 KB · Views: 0