chucma
Fractal Fanatic
Hi guys! I'm very confused about which cable I should use to connect my MFC101 MkIII to my Axe FX3. I don't really need bi-directional comms between the Axe and MFC, I literally just want my MFC to be able to change presets/scenes/bypass blocks and don't really mind about the MFC display not being in sync with the Axe FX. Also I’m powering the MFC with the wall plug.
I have a 5pin MIDI cable (both sides), but then the output on the MFC is a 7 pin, does that mean I need to get one of the 5-7pin MIDI cables as discussed in this thread?
Bidirectional midi?
Or can I just use the 5 pin cable? Is it safe to use a 5 pin male into a 7pin female?
I'm really not very experienced with MIDI here, so your patience/guidance would be greatly appreciated! I have been using the MFC with my XL and FASLink, hence my noob questions on the MIDI side.
I also wasn't sure if this post should go into the MFC forum, or the Axe3 forum, hope I got it right.
I have a 5pin MIDI cable (both sides), but then the output on the MFC is a 7 pin, does that mean I need to get one of the 5-7pin MIDI cables as discussed in this thread?
Bidirectional midi?
Or can I just use the 5 pin cable? Is it safe to use a 5 pin male into a 7pin female?
I'm really not very experienced with MIDI here, so your patience/guidance would be greatly appreciated! I have been using the MFC with my XL and FASLink, hence my noob questions on the MIDI side.
I also wasn't sure if this post should go into the MFC forum, or the Axe3 forum, hope I got it right.
Last edited: