• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

MFC v2.15 - IA default settings after updating firmware

tojoba

New here
Have searched on this topic but can't seem to find a thread that addresses my question, so I apologize if it has been answered before. After updating my MFC to 2.15, the default settings for my IA switches 1-17 have changed from what is represented on page 19 of the MFC manual. For example, IA #6 used to be for COMP1, IA #7 was DRIVE1, etc. Now, when the MFC fires up IA #9 is AMP and #10 is CAB and most of the other IA switches are not assigned.

Do I have a setting incorrect to have the default IA this way? I realize I can change my switches manually but just wanted to make sure I wasn't missing a quick fix.

Thanks.
 

guitargeorge

Inspired
Have searched on this topic but can't seem to find a thread that addresses my question, so I apologize if it has been answered before. After updating my MFC to 2.15, the default settings for my IA switches 1-17 have changed from what is represented on page 19 of the MFC manual. For example, IA #6 used to be for COMP1, IA #7 was DRIVE1, etc. Now, when the MFC fires up IA #9 is AMP and #10 is CAB and most of the other IA switches are not assigned.

Do I have a setting incorrect to have the default IA this way? I realize I can change my switches manually but just wanted to make sure I wasn't missing a quick fix.



Thanks.
Just reset your MFC-101 to factory default settings (reboot with switch 11 held down); the IA-switches should be the same as in the manual.
 
Top Bottom