camilovelandiamusic
Experienced
Hey guys!! In this video Im matching the Axe FX III to the Klon Centaur as best as I can!
Do you think you could use a tone match and capture it?matching the Axe FX III to the Klon Centaur
Im sure I could! But then I’d have to add an additional tone match block. I guess since I also use my AX8 every week Im thinking of a simple match for that too since I find that I use up the memory on that pretty quicklyDo you think you could use a tone match and capture it?
Some like the gain, some like to just use it with the Output up to push the amp, but I figured it I can capture the EQ color and a bit of the gain color, then its just a matter of turning Gain/Level up or down to taste as oppose to trying to match it with no gain and then guess what the color of the gain actually does as its turned up.i think the axe version has a little more treble, but they're very close
does anybody actually use their klon with all three knobs at 12 o/c?
i think the axe version has a little more treble, but they're very close
does anybody actually use their klon with all three knobs at 12 o/c?
does anybody actually use their klon
Hey guys!! In this video Im matching the Axe FX III to the Klon Centaur as best as I can!
Hey guys!! In this video Im matching the Axe FX III to the Klon Centaur as best as I can!
Thanks brother! Glad to help!Thank you thank you thank you!!! I just tried your settings and it’s blowing me away. The hours you spent on this were definitely not wasted.
The Klon (or in my case the Centura) proved frustrating because of the clean boost with inverse overdrive mix on the gain pot. Its an inverse taper dual pot so as you turn up the gain, your reducing the clean boost and adding more OD and vice versa. As such, the Axe emulated settings that can sound spot on at 9o'clock on the gain pot don't sound as accurate at say 11o'clock on the gain pot.
IIRC, I think Yek does something similar in some settings his shared a few months ago, changing the clip type in the Axe depending on how the actual pedal was set.
Essentially, if you set and forget the hardware pedal, then its a bit easier to match, but, if you often tweak the hardware pedal to different settings, you probably need to have a few different channels of the drive block with different clip types etc to best reproduce what is happening with just an adjust of a single knob on the pedal.