Niels Beier
Member
Hey guys,
I'm running my FX8 in front of my Marshall JVM model.
With my old setup, I ran a G-Lab GSC-3 looper in front of it, to do all my pedal-switching and channel changes via MIDI. Now that I've upgraded to the FX8, it's time for it to pick up where the G-Lab left off.
The thing is, I can't seem to get these two to work together. In a previous thread I mentioned a few issues I had with the FX8, and asked about MIDI.
My G-Lab looper could only send PC changes, and the Marshall picked those up perfectly, and made the correct channel switching. However, whatever I set the different MIDI-settings to, I just wind up with nothing..
In the I/O > MIDI settings in the Globals menu, I've got the following set up:
MIDI CHANNEL: 1
MIDI THRU: ON
PROG CHANGE: ON
For the individual scenes in my preset, I've got the following:
PC NUM: 8 (For that given channel on my Marshall. With the GSC-3, 8 meant OD-1, Orange)
PC CH: 1
CC NUM: OFF
CC CH: 1
CC VAL: 0
I've tried to change all values, including the CC's (though I don't see that being important, since my old looper didn't send CC, only PC)
What am I doing wrong here?
Note: I tried different MIDI cables, but it isn't a cable problem.
I'm running my FX8 in front of my Marshall JVM model.
With my old setup, I ran a G-Lab GSC-3 looper in front of it, to do all my pedal-switching and channel changes via MIDI. Now that I've upgraded to the FX8, it's time for it to pick up where the G-Lab left off.
The thing is, I can't seem to get these two to work together. In a previous thread I mentioned a few issues I had with the FX8, and asked about MIDI.
My G-Lab looper could only send PC changes, and the Marshall picked those up perfectly, and made the correct channel switching. However, whatever I set the different MIDI-settings to, I just wind up with nothing..
In the I/O > MIDI settings in the Globals menu, I've got the following set up:
MIDI CHANNEL: 1
MIDI THRU: ON
PROG CHANGE: ON
For the individual scenes in my preset, I've got the following:
PC NUM: 8 (For that given channel on my Marshall. With the GSC-3, 8 meant OD-1, Orange)
PC CH: 1
CC NUM: OFF
CC CH: 1
CC VAL: 0
I've tried to change all values, including the CC's (though I don't see that being important, since my old looper didn't send CC, only PC)
What am I doing wrong here?
Note: I tried different MIDI cables, but it isn't a cable problem.