Deadpool_25
Fractal Fanatic
My FM9 signal chain runs through parallel amp blocks with each amp hard panned. The amp blocks are set to mute on bypass. The amp blocks converge into a single reverb block and then go to output 1. Output 1 feeds two real amps’ FX loops/cabs.
When I mute an amp I still get the reverb through both cabs. Is there a way to keep the left/right input/output isolated through a single reverb block? So if I send it only a left input, it only outputs on the left side?
I know I can use two reverb blocks—just curious if you can do this with one.
When I mute an amp I still get the reverb through both cabs. Is there a way to keep the left/right input/output isolated through a single reverb block? So if I send it only a left input, it only outputs on the left side?
I know I can use two reverb blocks—just curious if you can do this with one.