Implemented Looper: Hitting ONCE while in RECORD should stop recording but not start playing immediately

Henry

Henry

Experienced
The current looper control does not allow for a loop to stop and not play immediately. At least I have not found a way so far.

The II looper implemented this by:
- stopping the recording when you hit Record (while recording)
- and setting the Immediate Play to Off.

The III looper goes into overdub when you hit Record while recording. I did not use overdub in the II looper, but I think it had a separate control for that (Stack, if I'm not mistaken).
 
I learned today that this can be done with existing III functionality.

If you don't want to have the loop start playing immediately:

Hit Record to start the loop, then at any time hit Once. At the end of the loop hit Record again. The loop does not start playing immediately, but is available with Play and Once later on.
 
It would be great if hitting ONCE while recording just closed stopped the loop. It’s tough to sing and play guitar needing to press 3 switches to do this.
 
You must log in or register to reply here.
Back
Top Bottom